Il mercato; tutte le auto prebelliche in vendita

Large Claxon type horn made by the American Bosch Magneto Corporation of Springfield (Mass.) USA - in good condition. Chrome will polish up. 14cms outer diameter.

Large Bluemell-type steering-wheel for English cars. Outer diameter 50cms. Diameter centre hole 3cms. Structurally in good condition but in need of light repairs to the outer rim. Location: UT BS

Drum-shaped headlight in good condition. No dents, only in need of a fresh coat of paint. N° on glass 553699. Probably off a truck. Outer diameter 15cms.

Older American updraught carburettor made by Kingston. Model L1, N° T 61361. Large 40mm throat. E.g. used on tractors and trucks. Good overall condition for age but cork float needs to be remade.

Lucas magneto for 4 cylinder-engine as used e.g. on Fordson E27n-tractors. In serviceable condition but bearing may have to be replaced.

Sankey type spoke wheel for a vintage car in good condition. 12 spokes, 20 inch and 6 studs. 124mm diameter centre hole and 161mm measured across the stud-holes.

Unknown make. One pair of horns for American cars in serviceable condition. Would benefit from a fresh coat of paint.

Large foglamp off an American car made by the S & M Lamp C° / N° 670 Los Angeles/USA. Good condition. Diameter 23cms measured across housing, 18cms in straight line. Marked 5 3/4 inch diameter on glass. Int. ref: OS 51H

Nos carburettor for Ford V8 flathead. Also used on Judson compressor.

Wire spoked wheel for pre-1925 American cars. 6 stud, for beaded edge tyres, 85mm width, overall diameter 644mm. Stud spacing 160mm. Three spokes need to be replaced. This pattern was made by several American manufactures including Hayes, Dayton and Houk for car such as Hupmobile, Buick and Marmon.