Il mercato; tutte le auto prebelliche in vendita

Panoramica degli annunci correlati all'annuncio Morris dashboard & interior for Morris

  • Morris doors (and door parts) for Morris

    Morris doors (and door parts) for Morris

    Pair of front doors for a circa 1937 Morris Eight Saloon. Good honest condition, only relatively minor welding in bottom corners required. Location: PS 1 2A
  • Morris coachwork (or parts) for Morris

    Morris coachwork (or parts) for Morris

    Pair of rear guards for a circa 1937 Morris Eight Saloon. Fairly good condition, not rusty only light panelwork required. Location: PS1 7A
  • Morris bonnet (bootlid) for Morris

    Morris bonnet (bootlid) for Morris

    Bonnet for a circa 1937 Morris Eight. Good condition, only some minor bruises. Location: PS1 8A
  • Morris axles front for Morris

    Morris axles front for Morris

    Front axle for ca. 1937 Morris Eight. In serviceable condition but brakes incomplete. (backing-plates only). Stamped number 73668, also 192. 530mm axle pads centres 669mm spring eye centres 973mm king pin approx. measured at top Location: AS 5
  • Rover dashboard & interior for Rover

    Rover dashboard & interior for Rover

    Complete dashboard off a Rover 90 or 95. Speedometer reads up to 100 m/hour, temp., amp. and fuel gauges all there. Also all knobs, switches, buttons and warning lights. All wiring still connected. No key.
  • Rover dashboard & interior for Rover

    Rover dashboard & interior for Rover

    Complete dashboard off a Rover 90 or 95. Speedometer reads up to 90 miles/hour. Temp., Amp and Fuelgauges all there. Also all knobs, switches, buttons and warning lights. All wiring still connected. Contact switch N° FA537. No key.
  • Morris axles front for Morris

    Morris axles front for Morris

    Set of new-old-stock king-pins and bushes for a Morris-Ten. Including two extra brass bushes, 1 ¼ inch long. These will not fit on Morris-Eight. pin diameter: 19mm / 99.2mm long brash bush OD: 22.85mm / 32mm long steel bush (brass lined): 22.85mm / 25mm long Location: UT HG 6B
  • Scintilla commutateur

    Scintilla commutateur

    Scintilla made in Switzerland commutateur type 19880les clefs fonctionnent manque un morceau de bakélite a l' arrière mais ne gène pas le fonctionnement .sur la face , manque  le Mika de la lampe témoin .diam 90 m/m pour un trou de 80 m/m.paypal accepté
  • Eureka gauges for Morris

    Eureka gauges for Morris

    Eureka oil-pressure gauge for vintage Morris cars in good condition. Diameter 6cms. Complete with mounting bracket.
  • Morris engine-s (and parts) for Morris

    Morris engine-s (and parts) for Morris

    One engine of an early 1930's Eight. N° 30124 A. Missing valves, distributor and carburettor. 2 bearing-crankshaft. Location: ES 1 3B

In primo piano